An Accurate Battery Charger SEPIC-Coupled Inductor Using Fuzzy Type 2
DOI:
https://doi.org/10.31963/intek.v8i1.2886Keywords:
SEPIC Coupled Inductor, Type 2 Fuzzy Logic Control, Constant Current-Constant VoltageAbstract
Recently, the needs of electrical energy have increased in line with the increasing population in Indonesia. Electrical in order to save the use of fossil energy, renewable is used, namely solar energy. Solar energy depends on the conditions of sunlight and the temperature of the solar panel. So, if the solar panel is directly connected to the battery, it will cause the battery be damaged. To overcome this, a controlled DC-DC converter is needed to stabilize the solar panel output before connecting to the battery. The DC-DC converter that used is a SEPIC coupled inductor converter, this converter has the ability to increase efficiency, the output polarity is not reversed, and avoid input current ripple. The control used to adjust the output of the SEPIC converter is a type 2 fuzzy logic controller because it has ability to find a set point value faster than other control logics and can handle uncertainty better than a type 1 fuzzy logic controller. The output of the SEPIC converter is used for charging lithium ion battery with a capacity 12V 21Ah. The output value of the SEPIC converter is 12.6V for charging voltage and 7A for charging current. The method used for battery charging is the constant current constant voltage method (cc-cv).References
R P Anggraini, M Z Efendi, and F D Murdianto “Modeling And Simulation Of Miso-Buck Converter Using Anfis On Dc Microgrid Dsitribution System,†in IOP Conference Series: Materials Science and Engineering ICIMECE, 2020, DOI: 10.1088/1757-899X/1096/1/012066
Taufik Hidayat, Mohammad Zaenal Efendi, and Farid Dwi Murdianto, “Maximum Power Tracking Point Interleaved Boost Converter Using Cuckoo Search Algorithm On The Nano Grid System,†in Journal on Advanced Research in Electrical Engineering, 2021, Vol. 5, No. 1
D J Triandy, E Wahjono, F D Murdianto “Design and Implementation of Bipolar Sepic-Cuk Converter with Fuzzy Logic Control for Battery Charging Application†in IOP Conference Series: Materials Science and Engineering ICIMECE, 2020, DOI: 10.1088/1757-899X/1096/1/012067
Farid Dwi Murdianto, Indhana Sudiharto, and Eni Wulandari “Perfomance Evaluation Zeta Converter Using PI Controller for Energy Management in DC Nanogrid Isolated System,†in 2021 INTEK Jurnal Penelitian, 2021, Vol. 8, No. 1, pp.37-42, DOI: http://dx.doi.org/10.31963/intek.v8il.2651
Saurabh Kumar, Rajat Kumar, and Navdeep Singh “Perfomance of Closed Loop SEPIC Converter with DC-DC Converter for Solar Energy System,†in 2017 International IEEE, 978-1-5090- 4426-9/17
Indhana Sudiharto, Farid Dwi Murdianto, Yahya Chusna Arif, Agus Tri Prasetyo, and Hendik Eko H S “Design and implementation SEPIC Converter Using PI Controller for Solution Power Quality Improvement,†in 2019 International Conference on Science and Technology ICST
Kaffin Uwais Ahmad, Suhariningsih, and farid Dwi Murdianto “Hybrid Modified PSO – IC Methods Based MPPT to Overcome Partial Shading†in International Journal on Electrical Engineering and Informatics, 2021, Vol. 13, No. 2, DOI: 10.15676/ijeei.2020.13.2.11
Van-Binh Vu., Duc-Hung Tran., & Woojin Choi “Implementation of the Constant Current and Constant Voltage Charge of Inductive Power Transfer Systems with the Double-Sided LCC Compensation Topology for Electric Vehicle Battery Charge Applications,†in 2017 IEEE International, 2017, DOI10.1109/TPEL.2017.2766605
Neily Itsqiyah Mufa’ary, Indhana Sudiharto, and Farid Dwi Murdianto “Comparison of FLC and ANFIS Methods to keep Constant Power Based on Zeta Converter,†in 2021 INTEK Jurnal Penelitian, 2021, Vol. 8, No. 1, pp. 21-29, DOI: http://dx.doi.org/10.31963/intek.v8il.2701
H. Suryoatmojo “Design Li-Po Battery Charger with Buck Converter under Partially CC-CV Method,†in 2020 International Seminar on Intelligent Technology and Its Applications, 2020. ISITIA,2020, 978-1-728-1-7413-6/20
Muhammad Khamim Asy’ari and Ali Musyafa’ “Design of Buck Converter Based on Interval Type-2 Fuzzy Logic Controller,†in 2018 International Seminar on Intelligent Technology and Its Applications, 2018. ISITIA, 978-1-5386-7654-7/18
Farid Dwi Murdianto., Ainur Rofiq Nansur., & Alfis Syah Laili Hermawan “Modeling and Simulation of MPPT Coupled Inductor Sepic Converter using Flower Pollination Algorithm (FPA) Method in DC Microgrid System,†in 2017 International Electronics Symposium on Engineering Technology and Applications IES-ETA, 2017. 978-1-5386-0712-1/17
Sara Hasanpour., Alfred Baghramian., & Hamed Mojallali “A New High Gain Coupled-Inductor SEPIC Converter for a Microgrid System,†in 2017 Power Electronics, Drive systems & Technologies Conference, 2017. PEDSTC, Mahshhad, Iran, 294-299. 978-1-5090-5766-5-17
Hossein Ardi., Ali Ajami., & Mehran Sabahi “A Sepic Based High Step-Up DC-DC Converter integrating coupled inductor for renewable energy applications,†in 2017 Power Electronics, Drive systems & Technologies Conference, 2017. PEDSTC, Mahshhad, Iran 978-1-5090-5766-5-17
Ali Monstaan, Jing Yuan, Yam Siwakoti, Soroush Esmaeili, and Frede Blaabjerg “A Trans-Inverse Coupled-Inductor Semi SEPIC DC/DC Converter with Full Control Range†in 2019 IEEE DOI 10.1109/TPEL.2019.2917306
Saeed M. Akhmadan, Reza P. R. Hasanzadeh, and Mayorkinos Papaelias, “Arbitary Crack Depth Profiling through ACFM Data using Type-2 Fuzzy Logic and PSO Algorithm,†in 2018 IEEE
K.A. Naik., & C.P. Gupta “Performance Comparison of Type-1 and Type-2 Fuzzy Logic Systems,†in 2017 International Conference on Signal Processing, Computing and Control (ISPCC), 2017, 978-1-5090-5838-9/17
Andry Meylani, Ade Silvia Handayani, and Ciksadan “Perbandingan Kinerja Sistem Logika Fuzzy Tipe-1 dan Interval Tipe-2 pada Aplikasi Mobile Robot,†in 2017 Annual Research Seminar, , ISBN: 979-587-705-4
Mohammed Y. Hasan, Hazem I. Ali, Haider M. Jassim, “Hybrid h-infinity Fuzzy Logic Controller Design,†in 2020 Journal of Engineer Science and Technology, Vol. 15, No. 1.
Farid Dwi Murdianto., Ainur Rofiq Nansur., Alfis Syah Laili Hermawan., & Rangga Eka Setiawan “Comparison Method of Flower Pollination Algorithm, Modified Particle Swarm Optimization and Perturb & Observe in MPPT Coupled Inductor Sepic Converter on DC Microgrid Isolated System,†in 2017 International Conference on Advanced Mechatronics, Intelligent Manufacture, and Industrial Automation (ICAMIMIA), 2017. 978-1-5386-2729-7/17
Ainur Rofiq Nansur., Alfis Syah Laili Hermawan., & Farid Dwi Murdianto “Constant Voltage Control Using Fuzzy Logic Controller (FLC) to Overcome the Unstable Output Voltage of MPPT in DC Microgrid System,†in 2018 International Electronics Symposium on Engineering Technology and Applications IES-ETA, 2018, 978-1-5386-8083-4/18
Lunde Ardhenta., Ramadhani Kurniawan Subroto., & Irfan Al Faruqi “An Improved PID Controller Using Fuzzy Logic for SEPIC DC/DC Converter,†in 2019 International Conference on Advanced Mechatronics, Intelligent Manufacture, and Industrial Automation (ICAMIMIA),2019, 978-1-7281-3090-3/19
Meryem Oudda and Abdeldjebar Hazzab “Fuzzy Logic Control of a SEPIC Converter for a Photovoltaic System,†in 2016 Journal of Fundamentals of Renewable Energy and Applications, DOI: 10.4172/2090-4541.1000212
Irianto, Farid Dwi Murdianto, Epyk Sunarno, and Dewinta Dwi Proboningtyas “Comparison Method of PI, PID and Fuzzy Logic Controller to Maintain Speed Stability in Single Phase Induction Motor,†in 2021 INTEK Jurnal Penelitian, 2021, Vol. 8, No. 1, pp. 7-16, DOI: http://dx.doi.org/10.31963/intek.v8il.2687
