Karakteristik Campuran AC-WC dengan Penambahan Limbah Plastik Low Density Polyethylene (LDPE)

Authors

  • Bustamin Abd. Razak Politeknik Negeri Ujung Pandang
  • Andi Erdiansa

DOI:

https://doi.org/10.31963/intek.v3i1.9

Abstract

This study aims to determine the effect of using plastic waste Low Density polyethylene ( LDPE ) on the characteristics of a mixture of AC- WC . This study used five plastic content variation is 1 % , 2 % , 3 % , 4 % , and 5 % to determine the characteristics of the AC- WC . The method used in this study is a test that aims marshall know the characteristics , the performance of the mixture , and the optimum level of use of asphalt in the mix AC- WC . The results showed that the characteristic value AC- WC that include the percentage of plastic content obtained from the testing of 1 % -5 % of the optimum bitumen content , if the levels of plastic in bitumen is added, the value of stability , flow , and marshall quotient increase and decrease unstable , while the value of VFB and the density increases, and the value of VIM and VMA decreases.

Author Biography

Bustamin Abd. Razak, Politeknik Negeri Ujung Pandang

Jurusan Teknik Sipil

References

Departemen Pekerjaan Umum. 2010.†Spesifikasi Umum

Bidang Jalan dan Jembatanâ€. Direktorat Jenderal Bina Marga.

Haryanto,2010. “Polimer Termoplastic dan Termosettingâ€,

(online) (http://www.chem-is-try.org. diakses 29 November

.

Restu, Henry MS.dan N. Antonius .2011. “ Karakteristik

Campuran AC-WC dengan Bahan Tambah Plastikâ€. Makassar.

S. Silvia. 2003 “Beton Aspal Campuran Panas,†Jakarta: granit.

Thamrin. 2011. “Limbah Plastik Dapat Memperkuat Aspalâ€,

(Online), (http://MedanPunya.com, diakses 29 November 2011)

Published

2016-04-01

Issue

Section

ARTICLES

Most read articles by the same author(s)