Perancangan dan Simulasi Sistem Kendali Kolektor Surya pada Sistem Pembangkit Daya Tenaga Matahari

Sonong Sonong, Apollo Apollo

Sari


This paper discussed about simulation of closed loop position control system of DC servo motor in solar collector thermal power plant application. When the input position that simulated with step signal given to motor, the positional information from an output potentiometer which is mechanically coupled to a motor is feedback to control amplifier. The references position input from input step is combined with the feedback signal at the input of the amplifier which drivers the motor in proportion to the difference between two signal. In this case, the position of DC servo motor controlled with PID controller. Simulation was created by Simulink toolbox of Matlab 6.50. we found constant PID control are Kp = 1, Ki = 0,4, and Kd = 0,5.

Teks Lengkap:

PDF


DOI: http://dx.doi.org/10.31963/sinergi.v12i1.1117

Refbacks

  • Saat ini tidak ada refbacks.


Publisher by:

Jurusan Teknik Mesin
Politeknik Negeri Ujung Pandang
Jalan Perintis Kemerdekaan KM.10 Tamalanrea
Makassar 90245
E-mail: sinergi@poliupg.ac.id

SINERGI Indexed by :

g61g61g61g61g61g61g61g61

Member of :

Creative Commons License

This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.